Contour Enthusiasts Group Archives Forums General Troubleshooting Blower doesn't work at all

Hey everyone,
I've just read the FAQ and did a couple diff searchs, and I still can't find a solution to my problem.

My blower for the heater doesn't work at all. I had the stereo out this past weekend to replace the headunit, then everything went back in. I did disconnect the battery while it was out if that means anything. I got in the car to drive to work today, and no fan. Nothing. Not on low, not on high. Everything worked perfect the very last time I was in it. Any ideas? Tomorrow I'm gonna check the resistor (although I don't think that's the problem since it doens't work on high). Oh ya, I checked fuse 37, and it was fine. Any advise, or things to check would be greatly appreciated. (If the resistor's fine, I'll prolly pull the blower motor and test it with a 12V source).

~Eric

Here is a schematic of the blower circuit, lacking fuse numbers [image][/image]Oftentimes, it is the fan switch.

Also check Fuse 42 in the Power Distribution Box next to the battery and check Relay 14 in the Passenger Compartment Fuse Box under the dash by the steering column.

It wasn't any of the above. Like an idiot, I forgot to mention the turn signals didn't work, but the 4-ways did. I did a quick search for the turn signal problem, and sure enough, SOLUTION!!! It was fuse 23 under the dash. It apparently controls the turn signals, blower, and reverse lights (so I guess I didn't have those either). I replaced it, and sure enough, all is well. Man I love this forum. I really really love this place!!!

~Eric
PS thanks for all those who gave advice.