Everyone has told me i need to have two keys to program a third. However, the HOWTO on this says this
Quote:
To program a new key:
Buy a PATS key and have it cut.
Using a currently working key, place it in the ignition and turn it ON until the dash lights come on.
Turn the ignition off, remove key.
Within 10(?)seconds, place the new key in the ignition, turn the ignition ON until the dash lights come on.
Wait a few seconds for the PATS LED to stop blinking,
Turn igniton off, remove key.
New key is now programmed. This will work for up to 16 keys. After that you have to go to the dealer to have the memory reset.
am i missing where the second key is needed?? a poor pocket decision at an amusement park has left me single keyed.
