Originally posted by RawBurt:
Do I need to remove my hub and have new studs pressed in?




im not sure if its as easy as normally replacing lug studs due to that oval-looking hole but if it is thens its very easy. you just hammer out the piece thats left, reach around ( ) and stick a new stud through the whole ( ) in front, put on the lug and tighten the poop out of it till the stud is alllll the way (ie the head of the stud is flush in the back).

i had similar drama constantly last year. i eventually found out that my rims needed hubcentric rings. after i added those, never had snapping lugs again.


Originally posted by Tourgasm:
Sometimes you can mess up a word so bad that spell check doens't know what the hell you're talking about.