Does anyone have a picture of a SVT throttle body gasket and a standard gasket.
I'm going back over what this looked like when I cleaned the TB and am unsure if I put the correct one in. I believe the one I put in had a notch at the very bottom on the interior passageway. It also had a rectangular hole cut-out that matched up with the UIM on the bottom side of the gasket. Although, the one I took off did not have this rectangular hole and there is a space in the UIM for this hole in the gasket. Aslo, the old gasket had three different notches forming around the bottom that when put on actually went inside the throttle body passageway.
Is this a difference in manufacturing/brands?
Thanks!
