Originally posted by vpogv: Originally posted by Tour_Racer00: This thread is too helpfull to let die...
Do you really need all of those special tools that the food service guide calls for besides the engine support bar? The only thing I haven't done in that guide is remove the fuel and ps rack lines and remove the cv shafts. As far as I know you only need the spindle nut socket. If there is more, I'm a fast learner
Are you pulling the engine or dropping the subframe? If you are pulling the engine the only "special" tool you need is to disconnect the fuel lines. Other than that it's all basic tools and sockets.
I should have responded to this last night after I made more progress. I'm dropping the subframe and taking the tranny out the bottom. Is the tool for the fuel line just a simple fuel line disconnect or is it a special tool that you have to get from ford? And why do you even have to disconnect the fuel line?
Alex
00 T-Red/Tan SVTC
#1964/2150
167 HP @6800
153 TQ @3000
Sold-
98 'Tour SE 24V 5-spd
149 HP @5900
148 LB FT @4300
|