I've been learning a new software for 3D modeling. Autodesks' Inventor. It's similar to Solidworks. Anyway, for a project I did to try and learn all the stuff it can do I thought I'd model an aftermarket turbo setup in the SRT-4. This model is approximately proportional since I don't know any dimensions on any of it. Well, the intercooler core is 24x12x4, so at least that is good, and everything else kind of went off of that.







what do you think?

Dave, '04 E. Blue Dodge SRT-4 ...with some go fast stuff...going for 20+psi (273 whp & 311 lb-ft with a boost leak) '03 Kawasaki ZX-6R 636