Originally posted by Y2KSVT:
Originally posted by tour96se:
............mark, i bought one for the pre98,you have to use the stock plastic frame and restaple the boot to it,so if you have a short throw shifter you can just staple the frame up farther ..btw the quality is great...but the boot for the pre98 ebrake wasnt even close to working...



I was only pointing this out, as the leather tends to need some overlap to have a nice fit. Not to say it can't be done, but when the boot is shorter, it's quite a bit easier. And again, it'll save on supplies in the long run.



OK, two important things.

1) You cannot shorten the boot by cutting off the top or stapling the frame deeper into the bottom of it. If you take a minute to think before you grab your stapler/scissors, it will be obvious why. It's a coned shape, after all.

2) We do make short shifter versions of all our boots. Just let us know how much shorter do you need it and consider it done. We don't charge extra for it either.

Maciek

RedlineGoods.com - genuine italian leather [url=http://www.redlinegoods.com]shift boot[url] custom made for your Contour!