as an edit to my previous post, the ball bearings are responsible for holding the switch in the parking light/fog light/off positions, not for pulling out the fogs. Just for the purposes of this post I pulled my headlight switch out and apart and examined it. There are two tabs on the switch and they ride on runners contained inside the orange plastic housing. In the off position these runners have a small incline on them which forces the fog switch to be pulled in. You can grind the two tabs on the switch, but what I would do is since the switch is apart, I would grind the two inclines level with the rest of the runners and that would facilitate the switch to be pulled out in any position. If you are really wanting to do this mod, post here and I will give you instructions. Once again, I apologize for the error.
