My tubular TCA's are for the rr of the car, not the front. As far as I know there are no tubular front control arms although someone "said" they would make them. This seems to be the norm here as talk's cheap. I have looked in to fabricating them from scratch but it is very difficult and the market is somewhat limited. I do have plan B though...
This would entail rebuilding the stock assemblies with polyurethane bushings which can be replaced when necessary. Now I do have to figure out how to fabricate the mounting pins and some kind of "thrust washer/bearing" set up to keep the arms from moving fore/aft when they're loaded.
Options w/b boxing, additional camber, etc. However, I can state that they will cost more than new Ford ones and I will only make them in the 4 bolt mount design.
Any interest?
Redcoat Raceworks. Performance parts and custom fabricating for Contours, Mystiques and Cougars. Specializing in chassis and suspension parts. Custom end links, control arms, strut tower bars, engine torque braces, etc.
| 
