Heat JUSt the pulley up with a propane torach so it gets nice and hot, but not too hot, then as it cools spray on some PB Blaster or liquid wrench around the journal so it loosen it up, then pull it off with a bearing-type puller.
2000 SVT Turbo 295hp/269ftlb@12psi
#1 for Bendix Brakes Kits!
Knuckles rebuilt w/new bearings $55
AUSSIE ENDLINKS $70
Gutted pre-cats $80/set
A lack of planning on your part does not constitute an emergency on mine!
