it is a fairly easy install, i did it the other day.
I baught a small battery from Advanced auto, a hacksaw and a 3 1/2 circle drill-cutter bit from Home Depot, and that was it.
Use a torq's bit to take out plastic fender thingy that attached to stock airbox.
Use the hack saw to cut the battery bracket right where the fusebox rested on (closest to the driver's light), this leaves you 5 bolt locations to attach the battery bracket back.
Then, drill the hole right below and a little to the right of where the rubber circle (where the wire goes to the fog light).
After whole is drilled, reinstall new battery all the way to left of bracket, use the battery tie down to hold in place.
Then, i had to un-attach the bracket that hooks up to the negative of the battery, use tin snips to trim it down, drill a hole in it and bolted it up to the old spot where the fuse box bolted to the bracket (sits right beneath the CAI now).
Looks very clean and almost like it was made for the contour.
If anyone wants to host pics for me i can send all the pics to them, then they can cut and paste this guide to those pics so it all makes sense. PM me if you want to get my step by step pics and make this a how-to.
Last edited by TrumpDrewSVT; 05/28/05 04:54 PM.
