Contour Enthusiasts Group Archives Forums Modifications General Mods A pillar removal?

I recently just received my A pillar gauge pod and gauges from SPmotorsports and was wondering what the easiest method is to remove the stock a pillar. I noticed there arent any screws visible on the regular a pillar but there are some on this replacement gauge pod, do I need to worry about breaking any mounts/brackets that i may need to screw into later? I have already searched but came up with nothing, I guess most people just figure it out on their own, I just want to get it right the first time . Thanks

Found It
-tropictour

awesome, I knew there was some sort of trick to it.

This is by far one of the easiest mods i've done. What gauges did you go with? Let me know of you need any help.

I got the phantom gauges. Oil pressure, water temp (stock one has been wacky since waterpump went out) and air fuel ratio. I have a friend that will wire all of the gauges for me I just need to install the gauge pod and break through the firewall if it hasnt been done already. The reason I was originally installing these was to give me an added piece of mind while driving and more of a precautionary measure. The way its looking though these gauges will just give me more things to stress about, I guess well have to see how it works out