Originally posted by mean'tour:
Originally posted by juices:
I'm planning on trying it to..

How to and pictures would be greatly appreciated.





There's a How-to here. Or Chrissilversvt just PM'd me some instructions as well:

*************************
first off find the brake booster(its a big round black thing on the rear firewall near the windshield)it also has the master cylinder attached to it.......

now take half the can of seafoam and pour it in a shallow bowl or container...this is what you'll suck into the vaccum hose.....

now there is a vaccum line attached to the brake booster with a plastic fitting....remove that line from the fitting(should just pull off)its also ok to remove it with the fitting(but will be easier to suck it in thru just the hose)remove this hose with the engine running...removing it will cause the car to run a little rough...if you have a helper have them sit in the car and give it enough gas to keep it running..or if by yourself use the throttle on side of throttlebody by hand to keep it revved enough to stay running...

now just slowly place the hose into the bowl and let it suck the seafoam out of the bowl until it has sucked it all in....it will only take a couple minutes to suck it all in...

now put the hose back on and shut off the car....and pour the other half in your gas tank...

let it sit for about 15-20 minutes....

after it has sat...start it back up and let it run a minute...there should be smoke coming out of the exhaust..this is normal as its the carbon burning off...the amount of smoke will vary by how dirty your engine is...now drive the car around a few minutes,it will smoke still....get on it pretty good a few times...after a few minutes it will stop smoking..then you are done...

it really is simple as that......hope this helps...as long as you can find that hose which is right on the front of the booster,you've got it made....
************************
But my problem (I'm a n00b to car maintenance) is that I don't know where these vaccum hoses are. Are these them? I would pry these loose and put some Sea Foam (or Berryman's B12, etc.) into these as the engine runs, right.

Please let me know, as I would like to try and do this cleaning this weekend, before I install my new plugs and wires...

THANKS ! ! !




Anyone have any photos or anything? I'm just not quite sure where to run the Sea Foam/ Berryman's B12.


MUST SELL - ECM computer new for a 98 V6 mtx + pats Now trolling in a Red Nissan 4 x 4