Originally posted by Pudmunkie:
Thats where I ran mine,

I had to push a large screw driver thru the insulation to see where it was pushing through. Then just cut the excess insulation out.



question: I ran mine through the gromet on the engine side of the fire wall but when you get it into the cowl, there is no gromet to go from the cowl into the bay of the car. There was a black patch (seemed to be made of rubber) i poked a screwdriver through that and poked through the insulation and had to tear it a little to get the wire through. But now if you shine a light down in the cowl you can see that where the power wire is going through the insulation it is definatly not sealed (there is gaps around the wire where insulation can be seen etc.) Im wondering if this could be a potential problem.

What did you guys use to seal up this hole? I was thinking about culking or a gromet but unfortunatly the hole isnt a circle, its more like a tear so i dont think putting a gromet in there will work.

Justin 98.5 CSVT # 4887 of 6535 (born 2/28/98)