Contour Enthusiasts Group Archives Forums General Pics and Videos ELKY's newest mesh, love how it looks

Originally posted by mygameisplatnum:

---

just finished installing it on my lower front and rear bumpers. It looks great. The precutting worked flawlessly. You did an excelent job. All you had to do was pre-line up the cutouts to make sure the tabs would all fit thorugh the cutouts and then press on. Great stuff.

question: ELKY what do you suggest to keep the aluminum from oxidizing? Just washing it everytime you wash the car? I thought about spraying a layer of clear on it but i already put it on the car? What do you suggest?

---

Originally posted by muskamike:

---

hey that looks great, this brings up a question which I might post later after researching (I'm currently at work with Rogers Wireless, heh)

Ummmmm, my question is, was there a stock holder for the front licesne plate, is that why the holes are so far apart? Also, I will post later as well, my previous owner drilled two holes for the plate on the lower half of the front bump, I believe to put the plate there, but again, no holder was inculded.

If you can link me or point me in the right direction it woudl be greatly appreciated.

---

I got plugs from my body shop painted and just pressed them in. You could probably also get some from Lowe's or Home Depot and paint them. Almost can't see them.