Contour Enthusiasts Group Archives Forums Modifications Zetec Maintenance Camshaft Alignment tool (or lack there of)

Print Thread

Re: Camshaft Alignment tool (or lack there of) #1236562 04/05/05 03:05 PM
Joined: Jul 2004 Posts: 862 9 96mercury Veteran CEG\'er
96mercury Veteran CEG\'er 9 Joined: Jul 2004 Posts: 862	or use a piece of 3/16 angle iron thats what I did and total cost was about $4 for 4 feet of the stuff. Just cut the overall length to 7 inches. BTW its a tight fit and the groves in the cam are offset so make sure they are on top otherwise it will never work. Good Luck ATX MTX swap, rear drum disc swap, drilled rotors, ported intake, optim throttle body, CAI, 7.5L MAF, adj. fuel regulator, longtube headers, underdrive pulley, no EGR, low inpedence bigger injectors, 2002 Focus Swap

Entire Thread
Subject	Posted By	Posted
Camshaft Alignment tool (or lack there of)	pdqford	04/05/05 01:30 PM
Re: Camshaft Alignment tool (or lack there of)	Kremithefrog	04/05/05 02:17 PM
Re: Camshaft Alignment tool (or lack there of)	pdqford	04/05/05 02:34 PM
Re: Camshaft Alignment tool (or lack there of)	96mercury	04/05/05 03:05 PM
Re: Camshaft Alignment tool (or lack there of)	BK4293_dup1	04/09/05 05:12 PM
Re: Camshaft Alignment tool (or lack there of)	BrApple_dup1	04/09/05 06:03 PM
Re: Camshaft Alignment tool (or lack there of)	volcar	04/10/05 06:01 PM
Re: Camshaft Alignment tool (or lack there of)	96mercury	04/10/05 06:38 PM
Re: Camshaft Alignment tool (or lack there of)	Swazo	04/10/05 09:29 PM
Re: Camshaft Alignment tool (or lack there of)	Kremithefrog	04/10/05 10:01 PM
Re: Camshaft Alignment tool (or lack there of)	The Davis	04/12/05 05:28 AM
Re: Camshaft Alignment tool (or lack there of)	IonNinja	04/12/05 09:25 AM
Re: Camshaft Alignment tool (or lack there of)	96mercury	04/12/05 03:01 PM

Link Copied to Clipboard