Originally posted by Stazi:
Drill it out a bit so it still stays in, but it's opened up, you know? Try that and see if it helps.



I'll slowly start drilling the hole bigger and bigger, until it hopefully fixes the problem.

Originally posted by Stazi:
PS when I installed my old one the grommet for the IAT fit fine with some force it'll pop through just fine.



There was no way in hell mine would fit through. Even when i took out the gromet it still didn't fit. Many different people tried with no success. So i ended up sanding down the ridge that goes around the IAT until it could slide in. I used enough high temp RTV silocone to make a nice seal, on the inside and outside of the pipe. Also i applied silicone to the remaining 3 inlets to ensure no leaks. Thanks for all the help, i really hope drilling this bigger does the trick!