Originally posted by 2kSVT:
I was able to replace mine at the starter solenoid. This is the first place the cable "splices" without replacing the whole cable assembly.Take the cap off and the 90 degree bent cable slides out of the assembly. Then put the new one back to back with the old one nad slide them both back into the solenoid assmeblt and put it back on the starter solenoid.



Rod,
Are you saying that you pulled both cable-ends out of the solenoid cap at the same time? I was hesitant to pull out the cable-end that went back into the depths of the engine, for fear that I would break it (cable shroud is brittle), and since i can't even see where that end goes, I didn't want to mess with it... Do you think I can get the cable-end that goes to the battery out of the solenoid cap without pulling out the other cable-end?
Thanks for your response.

Scott

2000 SE Sport V6 ATX Only mod is a JL 10 in the trunk