Of course with the steel tube being the largest hold up and the fab shop requiring special dies to bend a 24mm bar, one alternative would be to use a standard/common tube stock of 15/16. I will contact both the steel supplier and the fab shop to provide quotes for the revised material if you folks are interested? I'll pass this along to Stazi and see if he has any objections, it was his specification for 24mm bar and I do not want to overstep his design with out discussing it with him first.
Maxwell Church
Nemo Malus Felix
ATI Performance Engineering
47199 Cartier Drive
Wixom MI 48393
248*848*9200 ext 131
248*894*2219 direct
