Originally posted by rac74:
again...this is 1st operation, next operation would be to install piece into a indexer on milling machine and machine large round end into a square and machine a flat on the small end of the pin...then drill the 2 holes and slot accordinly to match the stock mounting pins. the slots would give u the adjustment needed for the alignment. we'll post pics after they're finished.
Can't wait to see your finished product. Did you leave the stock sleeve in the arms or press in a new 1?
Redcoat Raceworks. Performance parts and custom fabricating for Contours, Mystiques and Cougars. Specializing in chassis and suspension parts. Custom end links, control arms, strut tower bars, engine torque braces, etc.
| 
