Originally posted by Ray:
Alright, so you verified the motor works with 12V..
good.. now verify that the board is TRANSMITTING said 12V to the motor when it receives it via the incoming connection to the board (or that you are even GETTING 12V to the IMRC box itself.
use a multimeter and test to see if you have a 12V signal at one of the pins going into the IMRC when above the secondary opening point.. Since the motor works, I am thinking that you may not be receiving the correct signal in the first place..
Let us know what happened, and we can see where to go from there.
Ray
I will check it out tomorrow. Can i check this with the KOEO or will i need to have the engine running?
Thanks for the info.
CRASSELL
95 Contour V6 auto
96 Contour V6 5 spd
97 Contour 2.0 Auto
| 
