Originally posted by Russell-3L:
the program IMO just seems too basic to properly design a compliceted piece. simple pieces might be ok
You don't just draw a few shapes. You actually have to input the measurements of those shapes into the program. So unless your measurements are off, everything should be good.
Just keep in mind, you never just start cutting on an expensive material before doing some prototyping yourself first.
After going through both audio tutorials last night, I really like the program. Even if you never order anything from the company, this program alone could teach people alot about fabrication or just general mechanical design.
Phillip Jackson
`98 Mystique LS
262K+ and counting...
ATX rebuilt @ 151K
"This storm has broken me, my only friend!" RIP Dime
| 
