Originally posted by GForceAuto:
1. I want to buy this 2000 Focus Transmission for the 4.10 final.

2. Now I know the bellhousings are different, but can I take the bellhousing off of the tranny from the Duratec and bolt it up to the zetec transmission body with the duratec input shaft? Will this work?


1. Well for starters you have incorrect information.

V6 MTX = 4.06
I4 MTX = 3.84

2. Technically yes the halves will match, but it's not as simple a just swapping the input shaft.
For starters you will need to swap out the front seal, races & a bushing as well. I don't recall if the races require shimming but likely they will as everything has a specific clearance spec.

The MTX guru is Terry. You should try him at Fordcontour.org

2000 SVT #674 13.47 @ 102 - All Motor! It was not broke; Yet I fixed it anyway.