anyone got a picture showing this o-ring becasue today i got charged for 1.2hrs of labor for Ford to lift my car and try to install the wrong gasket for a total of $105CND. Then they claimed that the 2 hole gasket will not work since i got an after market headers and exhaust. the gasket that they were trying to install is the one that goes on the next joint right after the test pipe, but my argument wasn't going anywhere because i dont have the stock exhaust system and Ford's gaskets/rings will not work on my trubendz/MSDS exhaust setup.
So there is an O-ring type sealer thingy that goes in the donut shaped flange thingy.
95 SE MTX
DH UIM, 65mm TB, SC CAI, Quaife, Centerforce, Fidanza, UR Pulley, F/R Strut Braces, Cross Drilled Rotors, S.S. Brake Hoses, 18" Enkei RS5, SVT Engine Mounts+Inserts, MSDS & y-pipe, Trubendz resonated exhaust & MagnaFlow cat
| 
