Originally posted by Goonz SVT:how would I "bend" the shields? plus what would be needed to connect on the special H9 connectors?
Take the front cover off (the black piece) its held on by, IIRC, philips screws. With that out of the way you will see the cutoff shield, push it in about 1mm. No need to loosen anything. Power up the lamp with the cover off and check your results. Push it too far and your cutoff will get fuzzy, if that happens you have gone too far.
Ive done this on my E-codes and have done the opposite on my DOT lamps. Good results both times.
As for the H9 connectors, remove your old sockets and connect the new ones on. Quite simple, as long as you bought them when you bought your lamps. A temporary fix would be some small spade connectors but I wouldnt leave it that way because corossion would eventually occur.
A temporary fix would be some small spade connectors but I wouldnt leave it that way because corossion would eventually occur. 
