da red one:
En réponse à:

First you need to remove the little and almost none apparent round push pin on the trim that covers the screws for the mirror.

You remove this push pin and the screw that is hiding behind (a torx one if i remenber well), and pry off the trim. Then you will have access to the screws for the mirror.

Nic.



Ok, where is this push pin?



You should easily see it when you look at the trim. Check carefully at the trim and you should see a small cercle, that is it. Same color as your trim. About maximum 1/2in of diameter.

P.S. There is also a 8mm bolt on the right side of the trim that you have to remove for the mirror.

Nic.

Contour 99 MTX V6 fully loaded, stock with 110000km. Illuminated sunroof switch. About to do the mystique rear dome light conversion with eyeball dome light.