|
|
Joined: Jun 2004
Posts: 3,065
Hard-core CEG\'er
|
Hard-core CEG\'er
Joined: Jun 2004
Posts: 3,065 |
Originally posted by I-Dom-In-8: When your Od light starts flashing it pretty much means your trans is gone.
Umm... not really. A good fluid change will most likely fix it. Do the fill and drain technique, search in the transaxle forum. This was just covered not long ago, and has been in the past. See quote from unisys12 below about O/D light flashing.
Originally posted by unisys12: The reason it is shifting harshly, after the light starts flashing, is because the PCM has commanded the tranny be run in a Fail Safe Mode. In this mode, the trannys line pressure is up'ed to higer than normal pressure under all conditions. This higher than normal line pressure is what is causing the harsh shifts.
|
|
|
|
|
|