Originally posted by scottd60:
Did you try and box the stock rear control arms ? I know they are flimsy but if I box them in I think it will help quite a bit. Then maybe the bushings will also help out.
I figure it's worth a try. They can only be better afterwards.


Not necessarily...

I would not want to even touch them with heat personally. Either front or rear for that matter. IMO it would be easier to just make aluminum rear replacements then to try and weld the stock pieces with any success.

I added more rubber inserts to them. (yippee )
I almost just "filled" them with 94A but I did not have enough.. I only bought 2lbs and that did the two roll resistors, the empty spots in the trans & engine mounts, and the front LCAs.

2000 SVT #674 13.47 @ 102 - All Motor! It was not broke; Yet I fixed it anyway.