Originally posted by JohnHoward:
Originally posted by brapple:
yes the engine needs to be warmed up as the instructions say

I followed the instrustions and they worked fine, didn't consider anything else when i did it, I just followed the instructions



Well, the instructions do say to use the upper RIGHT pin for the jumper and if it worked on your 95 it should work on mine even if the numbers are different.

Like they say: When all else fails, follow the instructions.

Thanks.




the car I did this on was is a 95 Mystique with the zetec and a 5spd so that is nearly the same as your car, I also did the same on my fathers car and it work by following the direction

I never looked at the connector for numbers, I just matched it to the figure and plugged in and I got the codes so I never questioned it

- 95 Mystique LS - Zetec/5spd - 99 Contour SeVT Sport - Duratec/5spd Official NE-CEG Contour/Mustang Family