Rawburt - yes you will have to cut or dremel the tabs on the front. Per Stazi's suggestion I bent the mesh to the shape of the grille opening and then lined it up with the top middle 2 tabs. I had to trim the mesh on one side afterwards as it curves sightly upwards after assuming the shape of the grille.
It's a very tight fit on the tabs after you get it on, trust me you won't need anything else to hold it in place. Oh and I personally couldnt figure out how to get the stock mesh out without destroying it.
Hey Stazi - is there any point to those deflector-thingys on the sides of the stock mesh?
