Actually in the past I had to cut out sections of the mesh to accomodate the tabs, but with the larger mesh this isn't necessary. The holes are large enough as the are so you just slide the mesh over each of the tabs to get it into place then use the stock clips to secure it there.
2000 SVT Turbo 295hp/269ftlb@12psi
#1 for Bendix Brakes Kits!
Knuckles rebuilt w/new bearings $55
AUSSIE ENDLINKS $70
Gutted pre-cats $80/set
A lack of planning on your part does not constitute an emergency on mine!
