Warmonger: Can you post proper measurements for all the stuff you've got? I have extensively measured both upper and lower IM's, non SVT. Please post the inlet and outlet measurements (although I'm more interested in outlet no.'s).
BTW-The non SVT lower IM has a cast in "2.5" on the bottom. It uses 1.25(32mm) throttle plates and (if I've got this right) it's the same on all Duratecs until the E1 went to a 3.0 lower. Outlet diameters are 1.125 (28.5mm) primary and secondary.
Technical Director/Co-Owner Performance Fords-check out our new throttle body service 95 SE with lots of custom 1 off mods. All design, fabrication and installation by owner.
