Originally posted by DemonSVT:
Cut a slit in the intake inlet housing? Couple problems...
Structural integrity.
How to seal it 100%
How to slide in a perpendicular divider
I looked at the bottom of my manifold, and you can make a cut that stops just before the pcv inlet with a die grinder. shaping the insert plate will be where most of the work is, but it should be long enough that when the top makes contact with the roof of the manifold it will then be flush with the bottom outside surface of the manifold. Then just have someone who can weld aluminum weld it up. It wont affect structural integrity, and it will only leak if you welder sucks.
Upon more thought, I would also add a spacer plate to move the throttle blade away from the divider for less turbulence.
Should only cost about 20-30 bucks for welding.
As far as going back in case you dont lik it, you can cut it out the same way and reweld the slit.
warmonger
