OK, I took a look at a stock t-body to verify the location of the throttle shaft. It's approx. 1/2 inch from the upper IM mounting face. Assuming (hate that word) the SVT t-body is the same, a spacer would need to be at least 5/8 thick to allow the throttle plate to open fully. Yes, I was planning to include a splitter in this whole assembly. Back to the drawing board!
Technical Director/Co-Owner Performance Fords-check out our new throttle body service 95 SE with lots of custom 1 off mods. All design, fabrication and installation by owner.
