Originally posted by tblazer:
I have tried in the past to remove the vacuum lines that plug into the manifold, I assume these are the lines I need to unplug, and never did get them off. I was afraid of breaking them.



1- Use a 10mm open end wrench.
2- Place the open end against the vacuum line you want to remove.
3- Slide wrench down till you make contact with the "fitting" in the UIM.
4- Push down with the wrench on the fitting, as you pull up on the line to remove it.

Other people will say to just use a flat bladed screwdriver to release it, but the wrench makes more contact with the fitting.