I've read all the topic's on the low coolant light and they still haven't addressed the problem I'm seeing. It seems that my coolant overflow tank magnetic float isn't floating and it appears to not be floating after the engine comes up to operating temperature. I've tryed every coolant level imaginable in the overflow tant without out any success. I used my ohm meter to see exactly where I can get the 82 ohms by lowering any raising the sensor. Once it gets hot the sensor turns on when I pull it down at least over a half inch and this is with the tank 1" over the max level line. It appears my float is sinking. I've cleaned the tank and my coolant is fresh at about a 50/50 mix. Has anyone seen this or have any idea what going on. The only thing I can figure is the float must have some junk on it maybe. I have two sensors one with one of them being new and they both act the same. I'm about to just go get a new or used tank cause I'm tired of seeing that %$#@ light come on.
DaveNC
