Contour Enthusiasts Group Archives Forums General Troubleshooting Help with 2 power window problems.

Hi
Inside the door, the window is bolted to and orange bracket.
This bracket slides up/down the window regulator shaft. Most likely the bottom of the bracket has come off the metal shaft. Mine did this recently.
If you can get a hold of a Hanes manual it tells you exactly how to remove the door panel trim and window so you can fix it. There's a lot of fussing, but it actual quite easy to do.

Once your inside the door you have to line up the screws on the bracket with the holes in the door, just roll down the window til you line it up.

Unbolt the bracket from the window. Where the 2 bolts go through the window, there are two plastic clips and you must remove these. Once removed you can slide the window up and out the opening.

Now that the window is out, you can use the window switch to slide the bracket higher in the door, just above the middle bump in the door. This will give you enough play to pop the bottom of the bracket back on the metal guide.

If not you might have to undo the 2 bolts on each end of the metal shaft.

If the bracket is broken, I suggest a trip to the wreckers.

As for the switch not working another reason to go to the wreckers!

Oh and watch out for the black adhesive on the foam padding behind the door panel. It's nasty stuff!