Originally posted by Travis:
Well this manifold shown is actaully ordered up by the customer. He was a ford engineer and he knew exactly what lengths and cross section and plenum and everything else he wanted.





Anybody I know?

As far as sizing etc. I was just trying to make sure you weren't going "hmm, that looks about right"

and fwiw, I hear ya on the bellmouths, a good friend of mine (also a ford engineer) awhile back was spending a lot of time looking for pre-made ones he could weld on to his similar intake (for a 2.3T XR4Ti) I don't think he was ever succesful

Balance is the Key. rarasvt@comcast.net