Contour Enthusiasts Group Archives Forums General Troubleshooting Could it be an imrc problem?

I haven't looked at mine, but the few I have seen have a little plastic retainer that you just push the linkage into - SNAP it's in.

yeah I had the same problem those damn clips broke on mine I bought some new ones cleaned my UIM/LIM and TB. Car was sweet never ran better

I guess I'll take a trip to the stealership Monday. I've got some other assorted clips to replace that have either wandered off or broke. Thanks again A.H.

new imrc installed. car runs so much better now. pretty easy install.

Ater reading all of the IMRC heat failure articles I took the perty black valve cover facad off of my engine. I think that will help some of the heat get out until I figure something else out. I think I might have broke my IMRC clip or something when degumming my UIM. Altough that doesn't relate to heat, it sure got my attention.