Register Log In

Contour Enthusiasts Group Archives Forums Modifications Suspension End Links - Replacement

Print Thread

Page 2 of 2

1

2

Re: End Links - Replacement #914545 04/13/04 04:47 PM
Joined: Jun 2000 Posts: 3,496 San Jose, CA F Fmr12B_dup1 OP Hard-core CEG\'er
OP Fmr12B_dup1 Hard-core CEG\'er F Joined: Jun 2000 Posts: 3,496 San Jose, CA	Originally posted by ssmumich00: . . .hmmm, so what did TH say about these? Just curious. . . Originally posted by ghodge: The Performance Fords endlinks have a spherical rod end that allows for better articulation of the sway bar. Also Terry Haines had told me that simply putting poly bushings on the stock end links would cause the rubber bushing in the eye to wear out faster. Just some food for thought. From this post http://www.contour.org/ubbthreads/showthreaded.php?Cat=&Board=susp&Number=263558&page=&view=&sb=5&o=&vc=1 Money doesn't always bring happiness. People with ten million dollars are no happier than people with nine million dollars ~ Hobart Brown

Re: End Links - Replacement #914546 06/08/04 02:13 AM
Joined: Mar 2004 Posts: 8 Missouri D ds5192 Newbie
ds5192 Newbie D Joined: Mar 2004 Posts: 8 Missouri	what size of Energy Suspension poly bushings do I need to buy for the Aussie Bar? Can I get them from Summit Racing?Sorry, new to CEG and can't seem to find the exact sizes anywhere. My CSVT came with the Aussie, but the bushings are shot. Thanks -ds5192

Re: End Links - Replacement #914547 06/08/04 03:16 AM
Joined: May 2002 Posts: 21,653 Albany, Georgia K Kremithefrog I have no life
Kremithefrog I have no life K Joined: May 2002 Posts: 21,653 Albany, Georgia	24mm IIRC 98.5 SVT 91 Escort GT (almost sold) 96 ATX Zetec (i brake to watch you swerve) FS: SVT rear sway bar WTB: Very cheap beater CEG Dragon Run - October 13-15

Re: End Links - Replacement #914548 06/08/04 01:26 PM
Joined: Nov 2000 Posts: 10,015 The land of Vegemite and Foste... S Stazi Hard-core CEG'er
Stazi Hard-core CEG'er S Joined: Nov 2000 Posts: 10,015 The land of Vegemite and Foste...	Originally posted by ds5192: what size of Energy Suspension poly bushings do I need to buy for the Aussie Bar? Can I get them from Summit Racing?Sorry, new to CEG and can't seem to find the exact sizes anywhere. My CSVT came with the Aussie, but the bushings are shot. Thanks -ds5192 24mm is the correct size, but the 15/16" Prothane Bushings, in the SMALL design, from jcwhitney.com work perfectly. They were what was supplied with the Aussie bar when I sold them. 2000 SVT Turbo 295hp/269ftlb@12psi #1 for Bendix Brakes Kits! Knuckles rebuilt w/new bearings $55 AUSSIE ENDLINKS $70 Gutted pre-cats $80/set A lack of planning on your part does not constitute an emergency on mine!

Page 2 of 2

1

2

Moderated by Andy W._dup1, Auto-X Fil

Link Copied to Clipboard

Powered by UBB.threads™ PHP Forum Software 7.7.5