Contour Enthusiasts Group Archives Forums Modifications Zetec Maintenance How would these 16V Badges look for sidemarkers?

I saw these 16V Sidemarkers on http://www.zetecinside.com, and I wanted to know what you guys thought of this idea. I was thinking of taking off my SE badges on the sides and replacing them with the 16V Chrome badges.

They basically look like this:



Whatcha think?

Those prolly won't cover the (estimated) 5/8 of an inch hole...

I'm looking at the Volkswagen ones...



But if they are too expensive I'm just gonna' rice it.

Do you think those VW badges would look OK on a Contique?

Yeah, that Mondeo badge definately wouldn't cover up the hole if you have it. pre98's didn't have that hole in the fender. I think the VW emblems would look just fine, just not the red ones. You might try finding a Honda badge...as much as I hate to say it, you know they've got to have a lot of badges out there.

wow SQ+ came out of your hole :p ,it would be hard to find a honda badge that says 16v.you could always get an SIR badge though :p

Rynn you can wait and see, I'm going to check 'em out first. But it's Sunday so the Volk dealer isn't open...

I think that there will be a font confliction until I tint my sail panels...but then it should look good. Red wouldn't go good on my car 'cause it's a silver/black/chrome beast...but it would certainly stand out.

I'm kinda looking into getting some sort of I4 or inline four cylinder badge. I just havnt seen any out there yet. That and some 2.0 badges.

I would think finding a badge that says '16V' would be very very easy. Think of all the DOHC 4cyl motors out there these days. I bet Honda has a few.

Giovanni, if/when you do it, get pics! Good close-up ones too!

Thanks!

No interest in actually putting in sidemarkers?

$40, Audi dealer, dremel, done...