Forums Calendar Active Threads
Previous Thread
Next Thread
Print Thread
Last Few Mods
#300899 07/21/02 05:28 PM
Joined: Jun 2002
Posts: 19
Mississippi
C
Carter Offline OP
Junior Member
OP Offline
Carter
Junior Member
C
Joined: Jun 2002
Posts: 19
Mississippi
I am going to go with the jet performance chip..anyone intalled one yet? I also plan to put an adjustable cam gear on the intake..anyone with knowledge of about where to set the cam + or - degrees? Anyways after that i am done. I am not going to put anymore into the old zetec except for maybe another pipe so my rear ues both exhaust cutouts... :rolleyes: frown

1996 Contour GL ATX MODS: cta intake essilenger udp odp 9mm ford racing wires hp accel coil custom fog lights SVT TRIM WILL POST PICS SOON 2 sets of 17 in rims custom wood dash magnaflow exhaust
Re: Last Few Mods
#300900 07/22/02 12:36 AM
Joined: May 2001
Posts: 620
Oakland, CA
P
Paul Kienitz Offline
Member
Offline
Paul Kienitz
Member
P
Joined: May 2001
Posts: 620
Oakland, CA
Have you heard anything about whether the Jet chip has any edge over the DiabloSport chip or the SuperChip?

96 GL Zetec ATX, white with pinstripe, nickname " Sam Smooth "
mods so far: CTA intake with homemade heat shield, KVR drilled front rotors & carbon pads w/ 500° fluid
planned mods: exhaust (want to keep it quiet), e-ram (awaiting installation), diablo chip
involuntary mods: compression increased after head gasket failure

Moderated by  Lance Kinley_dup1, Loco4G63 

Link Copied to Clipboard
Forum Rules · Mark All Read Contact Us · Forum Help · Contour Enthusiasts Group Archives
Powered by UBB.threads™ PHP Forum Software 7.7.5