Previous Thread
Next Thread
Print Thread
#1620051 07/30/06 05:56 PM
Joined: Jul 2006
Posts: 2
S
stevef Offline OP
Newbie
OP Offline
Newbie
S
Joined: Jul 2006
Posts: 2
Hi guys, I live in the UK so my car is the mondeo 2.5L 24v manual.
This noise has got worse over the last 6 months, sounds like the exhaust manifold blowing on one cylinder(front bank) at the timming chain end of the engine, thats been checked out OK and put back on with a new gasket, noise still there, had a compression test done on the front cylinders, all about 14 bar so OK.
Anyone any ideas?
Thanks.

#1620052 07/30/06 07:29 PM
Joined: Jan 2006
Posts: 47
D
New CEG\'er
Offline
New CEG\'er
D
Joined: Jan 2006
Posts: 47
Do a complete check of all of the vacuum lines. Check for cracked or collapsed lines. Replace any that are questionable. Are you showing any engine codes?


Good Luck Dan 96 SE 2.5 V-6 89 Silverado 4 x 4 with snow plow no rust
#1620053 07/30/06 07:47 PM
Joined: Jul 2006
Posts: 2
S
stevef Offline OP
Newbie
OP Offline
Newbie
S
Joined: Jul 2006
Posts: 2
Hi, haven't got a code reader, but the car runs good, starts 1st time and is OK for fuel comsuption, just this damn noise, also I forgot to say it gets louder when the engine is warm and under load, there are no vacuum hoses in the area only the A/C pipes to the compressor which has no gas in it due to a hole in the condensor.

#1620054 07/30/06 08:21 PM
Joined: Jun 2005
Posts: 5,345
T
Addicted CEG\'er
Offline
Addicted CEG\'er
T
Joined: Jun 2005
Posts: 5,345
Welcome stevef . Try spraying carb cleaner at hoses and gaskets while the car is idling. If the idle changes, you found the leak.


"Always do the cheap and easy ones first." 1996 V6 ATX 96K miles
#1620055 07/31/06 10:16 PM
Joined: Mar 2005
Posts: 52
R
CEG\'er
Offline
CEG\'er
R
Joined: Mar 2005
Posts: 52
Hey steve,
I heard a similar sound in my car, had it there and had some of the symptoms that it sounds like you were having, I wound up having a cracked exhaust manifold. I am definitely not an expert on these cars...yet, but that was my problem....


Why the heck should I have to press 1 for English? 98 Contour SVT resinator removed, boomz intake, MSDS headers(just getting started)

Moderated by  horseydug_dup1, Ray_dup1 

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.5