Register Log In

Contour Enthusiasts Group Archives Forums General Troubleshooting CEL P0136

Print Thread

CEL P0136 #1614575 07/21/06 03:36 PM
Joined: May 2006 Posts: 36 Is confused a place? I iluvmytour OP New CEG\'er
OP iluvmytour New CEG\'er I Joined: May 2006 Posts: 36 Is confused a place?	P0136 Downstream Heated Oxygen Sensor circuit fault - Bank No. 1 This is very strange. I just got this read at AZ. The problem is I have MIL eliminators installed, and just finished a 1500 mile trip and no CEL. I'm driving around town yesterday in 99F heat...and there it pops? One thing I can think of...is that my IAC tube slipped off my CTA intake...so I was sucking a lot of air post-MAF when the CEL came on. Could this have been what caused this? TIA

Re: CEL P0136 #1614576 07/21/06 03:40 PM
Joined: Jun 2005 Posts: 5,345 Virginia, USA T Tony2005 Addicted CEG\'er
Tony2005 Addicted CEG\'er T Joined: Jun 2005 Posts: 5,345 Virginia, USA	Originally posted by iluvmytour: P0136 Downstream Heated Oxygen Sensor circuit fault - Bank No. 1 ..is that my IAC tube slipped off my CTA intake...so I was sucking a lot of air post-MAF when the CEL came on. Could this have been what caused this? No. Either defective mileliminator, water got in the connector or the wiring come loose from the splice. I would check the connector as well as the splice. "Always do the cheap and easy ones first." 1996 V6 ATX 96K miles

Moderated by horseydug_dup1, Ray_dup1

Link Copied to Clipboard

Powered by UBB.threads™ PHP Forum Software 7.7.5