What is it you guys use when you install headers on a OBDII car to fake out the EGO monitor? I know there is a little plug or jumper to complete the circuit.
Any help would be great.
I am thinking of geeting headers as my cats are bad. I need to get a SMOG test next week.
Bill Jenkins
I am moving to Team Ford as of 08/01/05 (www.teamfordlv.com). I will post new info when it's ready.
Yea I put O2/MIL Elminators on my true dual set up, cuz Im runnin with no cats. It basically fakes the computer into thinking that there are cats...does quite a good job too if I must say...
Failure is simply the opportunity to begin again, this time more intelligently.
You didn't say what brand of headers you were thinking of installing. If you go with the MSDS headers they include MIL eliminators for the two downstream O2 sensors.
If you are handy with electronics and a soldering iron, you can make your own for a buck or two.
Each is only a resistor and capacitor along with some wire.
Have the schematic around someplace, probably on my old hard drive...
Steve
98 Contour SE Sport 2.5 Duratec ATX The wifey's car
89 Taurus SHO - 246K miles
94 SHO ATX - 190K
1997 F-150 5.4L ATX - The Workhorse 150K.
ANY THREAD WITH "OMG" or "WTF" ETC IN THE TITLE WILL BE IGNORED!