Contour Enthusiasts Group Archives
Posted By: Shaggy_dup1 Aftermarket electric water sender - 08/15/02 11:42 PM
All:
I've posted this question on some other boards, but I'd like to hear from the power of the CEG.

Where is the best place to install an Autometer electrical water temp sender. It was suggested to get a y connection where the stock sender is. Is that a good idea? It was also suggested to install the sender in the frost plugs.

Any tips/hints?

TIA!
Posted By: Micah_dup1 Re: Aftermarket electric water sender - 08/16/02 07:26 AM
take a knife cut an hose stick it in there duck tape it back up and call it frankencooler


Micah
Posted By: Shaggy_dup1 Re: Aftermarket electric water sender - 08/16/02 02:53 PM
In reply to:

Originally posted by mdawg28
take a knife cut an hose stick it in there duck tape it back up and call it frankencooler

Micah


I like it! Frankentrans needs a buddy, so welcome to frankengauges!

Seriously though, I think I'm going to try out the y split at the OE point.
Posted By: bnoon_dup1 Re: Aftermarket electric water sender - 08/16/02 03:28 PM
A Y split at the stock sender should work fine, plus it's in the water cross over tube which can be easily replaced if you "F" it up beyond repair.
© CEG Archives