-
Welcome to the Contour Enthusiasts Group, the best resource for the Ford Contour and Mercury Mystique.
You can register to join the community.
DFW junkyards?
- Thread starter bohdi
- Start date
99RedCSVT
Veteran CEG'er
When going to a junkyard, take an abundace of tools. Usually you can get by using just a craftsman 36 piece set and some plyers. Should be good. On the contour, you'll focus on 10mm, 15mm, 13mm, 17mm. Some other sizes but that is about most of the bolts.
Take some Torx bits for the braking hardware (among other things) T48, T50, and T55 are three main ones.
an EXTENSION (or even two!!) to remove the buried bolts, and a swivel or two.
Take a small hammer and a large mallet if you need to beat something off of a rusted piece, etc.
an EXTENSION (or even two!!) to remove the buried bolts, and a swivel or two.
Take a small hammer and a large mallet if you need to beat something off of a rusted piece, etc.
68fordman
CEG'er
in Arlington, by Six Flags on Jefferson (take the division exit on 360) there are a 
-load of junkyards, i havent stopped in any of them so i cant really tell you of any SVT's but still there's like 6 or 7 side-by-side
-load of junkyards, i havent stopped in any of them so i cant really tell you of any SVT's but still there's like 6 or 7 side-by-side