P1000 code help ?

[HAZZARD]

I just got the car back from the dealer with a new ECU. Its giving me a trouble code of

P1000 OBD-II Monitor Testing Incomplete
and all i get is a starter click like the battery is dead, i have it on a high powered shop charger in start mode, this thing will start a car with no battery.

anybody got a clue?


Thanks
Matt

 

[HAZZARD]

got the anwser on ford-trucks.com

This is not a fault code. It is an indicator code that simply means all the self-tests have not been run yet since the last computer reset


I have to run it a few times and the computer will do a self check and give a pass or fail and the MIL can be reset.


now try to start it.

 

[Big Jim]

Also, the P1000 code pops up any time the battery is disconnected or discharged. You may continue to get it to pop up until you resolve the starter/battery/electrical problem.

Start by testing the battery. What to test next depends on what you find with the battery.

 

[BrApple]

Also, the P1000 code pops up any time the battery is disconnected or discharged. You may continue to get it to pop up until you resolve the starter/battery/electrical problem.

Start by testing the battery. What to test next depends on what you find with the battery.

lol, I have had a P1000 since march when I did the 3L and then the turbo kit, consistantly swapping tunes out of the pcm. but I know by my scanner that only one self test hasn't run.

 

[HAZZARD]

Got it started, the terminals were corded on the inside, cleaned them started right up.

After i started it a few times the light went out and lost the code.

Now my throughout bearing is leaking, brand new went in with the new clutch, 0 miles on it and i got to pull the engin and trans again! :blackeye:

Thanks for listing to my rants