crewchiefpro
Hard-core CEG'er
Will one of these swap into a SVT like a 3.0 does?
I have one available from a brand new destroyed Edge.
I have one available from a brand new destroyed Edge.
-
Welcome to the Contour Enthusiasts Group, the best resource for the Ford Contour and Mercury Mystique.
You can register to join the community.
3.5 Engine out of a Ford Edge
- Thread starter crewchiefpro
- Start date
beyondloadedSE
Hard-core CEG'er
Mystique97
Veteran CEG'er
NO!
10char
10char
Last edited:
beyondloadedSE
Hard-core CEG'er
Its been shortened to 5 characters.
Anyways, back on topic. Its not a direct swap. Nothing is similar except it carries the name 'duratec'. Could you make it fit with LOADS of money. Sure. Anything is possible.
CSVT#49
Addicted CEG'er
You know what... yes we've seen this type of post quite a bit, but everyone is always like... No, can't do it, to much work, to much money.
Man if you have the engine and the time and a spare car... go for it. I want to see someone attempt it. Honestly I think it could be done if the person doing it has some good fabrication skills. After seeing some of the stuff at this car show this weekend this would be a cake walk.
DO IT!
Man if you have the engine and the time and a spare car... go for it. I want to see someone attempt it. Honestly I think it could be done if the person doing it has some good fabrication skills. After seeing some of the stuff at this car show this weekend this would be a cake walk.
DO IT!
biminiLX
Hard-core CEG'er
Agreed. If its something you want to attempt and have enough mechanical knowledge, start taking some measurements and see if its possible for reasonable effort and money.
I'm sure someone will try sooner or later.
-J
CSVT#49
Addicted CEG'er
Mystique97
Veteran CEG'er
Its been shortened to 5 characters.
Opps, how the hell did I miss that.