Hey all, im a NECO member looking into getting an ATX cooler. There are only like 1 or 2 people on NECO with a cooler, so theres not much help there. I did quite a bit of searching here about the cooler, and found quite a bit (like im gonna need a good buddy and 5-6 beers )
But what I didnt find was which fitting do i need?
The duckbill or the deep thread?
Im guessing (hoping) that our cars are the same in respect to the setup of tranny , and someone who has done this will know.
DUCKBILL
[image]http://www.fastcougar.com/forums/attachments/fittingduckbill%2Ejpg[/image]
DEEP THREAD
[image]http://www.fastcougar.com/forums/attachments/fittingdeepthread%2Ejpg[/image]

thx in advance!

-shin

EDIT: Why are my images not working?

All links to images have to end with '.jpg'.
Look at your link, it doesn't end with that.

DUCKBILL

DEEP THREAD

OK, well thank you for answering that question...but which fitting do I use????

I would buy two of each and then coording to how you route your hoses,
one or the other would be appropriate to use, depending on the route
that the cooler line hoses take to and from the cooler.

Ideally, you want to remove the rubber hose from the RETURN line,
and utilize those fittings with the cooling lines.
The cooler should be inline between the radiator outlet and the transmission return inlet.